研究證明，超聲波作用于液體時，液體中每個氣泡的破裂都會產生能量巨大的沖擊波，相當于瞬間幾百度的高溫，高達幾千個大氣壓，這種現象被稱為“空化”，超聲波自動清洗機是利用液體中氣泡破裂產生的沖擊波來清洗工件的內外表面，超聲波在液體中傳播，使液體和清洗槽以超聲波頻率一起振動，當液體和清洗槽振動時，它們有自己的固有頻率，也就是聲波的頻率，所以人們聽到嗡嗡聲。
Research has proved that when ultrasound acts on the liquid, the rupture of each bubble in the liquid will produce a shock wave with huge energy, which is equivalent to a few hundred degrees of high temperature in an instant and up to thousands of atmospheric pressure. This phenomenon is called "cavitation". The ultrasonic automatic cleaning machine uses the shock wave generated by the bubble rupture in the liquid to clean the internal and external surfaces of the workpiece, and the ultrasonic wave propagates in the liquid, making the liquid and the cleaning tank vibrate with ultrasonic frequency, When the liquid and cleaning tank vibrate, they have their own natural frequency, that is, the frequency of sound waves, so people can hear buzzing.
超聲波自動清洗機的原理主要是通過換能器將功率超聲頻率源的聲能轉化為機械振動，通過清洗罐壁向罐內的清洗液輻射超聲波，主要由超聲波清洗槽和超聲波發生器組成，超聲波自動清洗機的清潔方式：區分全封閉式和半封閉式，觸摸屏操作全過程由電腦控制，大大降低勞動強度。
The principle of the ultrasonic automatic cleaning machine is to convert the sound energy of the power ultrasonic frequency source into mechanical vibration through the transducer, and radiate the ultrasonic wave through the cleaning tank wall to the cleaning fluid in the tank, which is mainly composed of the ultrasonic cleaning tank and the ultrasonic generator. The cleaning method of the ultrasonic automatic cleaning machine is to distinguish the fully closed type and the semi-closed type. The whole process of the touch screen operation is controlled by the computer, which greatly reduces the labor intensity.
超聲波自動清洗機的維護可以保持和恢復設備的技術特性，保持設備具有良好的可用性和可靠性，為了使超聲波自動清洗機，正常高效的工作，必要的維護可以延長設備的使用壽命，一般維護周期為15天。
The maintenance of the ultrasonic automatic cleaning machine can maintain and restore the technical characteristics of the equipment and maintain the equipment with good availability and reliability. In order to make the ultrasonic automatic cleaning machine work normally and efficiently, the necessary maintenance can extend the service life of the equipment. The general maintenance cycle is 15 days.

超聲波自動清洗機的日常維護：
Routine maintenance of ultrasonic automatic cleaning machine:
1.保持設備工作場所通風、干燥、清潔，有利于設備的長期高效運行和工作環境條件的優化;
1. Keep the equipment workplace ventilated, dry and clean, which is conducive to the long-term and efficient operation of the equipment and the optimization of working environment conditions;
2.當清洗液太臟時，要及時處理，定期清洗清洗槽和儲液槽內的污垢，保持清洗槽及其外觀的清潔，提高清洗槽的耐久性;
2. When the cleaning fluid is too dirty, it should be treated in time. Clean the dirt in the cleaning tank and the storage tank regularly, keep the cleaning tank and its appearance clean, and improve the durability of the cleaning tank;
3.保持電氣控制箱和設備通風口遠離水蒸氣、腐蝕性氣體和灰塵，并定期用壓縮空氣清理附著的灰塵;
3. Keep the electrical control box and equipment vent away from water vapor, corrosive gas and dust, and regularly clean the attached dust with compressed air;
4.定期測試設備的絕緣性能，定期檢查老化的電器元件，檢查接地線，確保設備接地良好，該項目應由具有經驗的電工實施;
4. Regularly test the insulation performance of the equipment, regularly check the aging electrical components, and check the grounding wire to ensure that the equipment is well grounded. This project should be implemented by electricians with professional experience;
5.定期測試電源，確認符合設備的供電電壓要求，避免在過高或過低的不穩定電源下長時間運行;
5. Regularly test the power supply to confirm that it meets the power supply voltage requirements of the equipment, and avoid long-time operation under too high or too low unstable power supply;
6.對于有過濾裝置的設備，定期更換濾芯;
6. For equipment with filtering device, replace the filter element regularly;
7.帶傳動機構，按要求定期添加黃油、潤滑油等潤滑油，定期更換減速機齒輪油，保證運動部件在良好的潤滑條件下工作;
7. With the transmission mechanism, add grease, lubricating oil and other lubricating oil regularly as required, and replace the gear oil of the reducer regularly to ensure that the moving parts work under good lubricating conditions;
8.如果發現清洗箱和管道內有沉淀物，應及時清洗;定期更換清洗液，建議15到20天。在排放清洗液之前，確保設備已經停止。
8. If sediment is found in the cleaning tank and pipeline, it shall be cleaned in time; Replace the cleaning fluid regularly, 15 to 20 days is recommended. Before draining the cleaning fluid, make sure that the equipment has stopped.
本文由全自動超聲波清洗機友情奉獻.更多有關的知識請點擊:http://www.szoudao.com  真誠的態度.為您提供為全面的服務.更多有關的知識我們將會陸續向大家奉獻.敬請期待
This article is dedicated by the automatic ultrasonic cleaning machine. For more information, please click: http://www.szoudao.com Sincere attitude. We will provide you with comprehensive services. We will continue to offer you more relevant knowledge. Please look forward to it